To retrieve data from or delete data from an old hard drive, you need a hard drive reader. How to connect it to your hard drive? How to access your data? This post provides details about the hard drive reader.
What Is Hard Drive Reader?
A hard drive reader is a device that can be connected to a computer and allows a hard disk designed as an internal device to be effectively used as external storage. This type of device is great for people who have upgraded their computers and may have extra hard drives from older computers that still have data on them.
These devices can be simple adapter cables that connect to the hard drive and plug into a Universal Serial Bus (USB) port on your computer, or they can be hardware that allows the drive to connect to the device. Readers often allow hard drives to function like fairly portable mass media devices.
Tip: To get more information about the hard drive, you can go to the MiniTool official website.
How to Connect It to Your Hard Drive?
A laptop hard drive reader is available to allow the user to connect one end to the internal hard drive’s pin connector and the other end to a USB port on the computer. Because USB can also deliver power to the device, these adapters can sometimes provide the power the hard drive needs to run, although the drive’s power adapter may also be necessary. The connected hard drive will appear to the computer as an external media device and the data on it can be accessed accordingly.
An external hard drive reader can also be hardware that can connect to a hard drive, allowing it to interface with a computer. This is usually done through a USB port as well, but not just a wire, usually a docking station or adapter for the hard drive.
The connector on the hard drive connects to an adapter or docking station, and the device connects to the computer. This type of card reader usually works much like a connector cable, and the drive will appear as external memory. However, these readers are likely to be more stable than adapter cables, so hard drives that are frequently read can benefit from such devices.
So, after getting the hardware, you need to connect the disk to it, and then connect the hardware to the PC.
- If you use a dock. In this case, connecting the dock to the computer is no different than connecting an external drive. Just insert the old hard drive into the slot and open the dock.
- If you use an adapter. In this case, you need to use the appropriate side of the adapter (it has a side for 3.5 IDE, 2.5 IDE, and SATA). Now plug the adapter into a USB port on your computer, then plug it into a power source through the Molex adapter. Turn on the switch on the power cord to power the drive. If you have an IDE drive, the jumper on the drive must be set to Master.
Other Way to Access Your Data
Any hard drive can be connected directly to the PC with a cable that runs directly to the motherboard. The exact steps will again depend on the HDD connector type:
- Connect the SATA drive to the motherboard using a SATA cable.
- IDE drives use IDE ribbon cables, so motherboards need to have compatible ports.
If no compatible port is available, you’ll need a compact adapter small enough to fit in your PC case. Note that this is not a long-term solution. After the data has been recovered and copied to the new HDD or SSD, stop using the adapter.
Of course, before installing anything on your PC, you should make sure you know what you’re doing. With the HDD properly connected to your PC’s motherboard, it should be safe to start your computer and browse the device.
Here are all the details about the hard drive reader. I hope that this post can be helpful to you.